European Sealing Association
Gaskets for tongue & groove application - Printable Version

+- European Sealing Association (https://forum.bacibg.org)
+-- Forum: Flange Gaskets (https://forum.bacibg.org/forumdisplay.php?fid=1)
+--- Forum: Gasket Database (https://forum.bacibg.org/forumdisplay.php?fid=2)
+---- Forum: ESAData Approved Datasheets (https://forum.bacibg.org/forumdisplay.php?fid=10)
+---- Thread: Gaskets for tongue & groove application (/showthread.php?tid=155)



Gaskets for tongue & groove application - AMTEC - 03-31-2021

In EN 13555 there are the following dimensions for the test samples defined:



1. DN40/PN40 according EN 1514-1 to EN 1514-7


2. NPS 4 Class 300 according to EN 12560-1 to  EN 12560-7


3. For the use in a tongue and groove, the gasket must fit into the groove of EN 1092-1 or EN 1759-1 unstead of having the geometry of EN 1514 or EN 12560 series


4.For tapes an outer diameter of 110 mm is defined




Shall the gasket characteristics for tongue & groove application be listed together with the EN1514 or EN 12560 characteristics, or shall they be listed in one category "Type TG" for all gasket types, or do we need for each gasket type an additional category (e.g. "Type TG - sheet gasket").



Please select one of the options in the poll or share your opinion in a post.


RE: Gaskets for tonge & groove application - SGL - 03-31-2021

I think we could add the TG gaskets into the "non-standard" folders.