European Sealing Association
Donit Tesnit Grafilit EM 1.5 mm - Printable Version

+- European Sealing Association (https://forum.bacibg.org)
+-- Forum: Flange Gaskets (https://forum.bacibg.org/forumdisplay.php?fid=1)
+--- Forum: Gasket Database (https://forum.bacibg.org/forumdisplay.php?fid=2)
+---- Forum: ESAData Approved Datasheets (https://forum.bacibg.org/forumdisplay.php?fid=10)
+---- Thread: Donit Tesnit Grafilit EM 1.5 mm (/showthread.php?tid=16)



Donit Tesnit Grafilit EM 1.5 mm - root - 01-06-2020

Approval of Data Import from gasketdata.org

Type: sheet gasket
Publication: 8/14/2019

Link to gasketdata.org


RE: Donit Tesnit Grafilit EM 1.5 mm - SGL - 05-20-2020

Leakage cross check at 40 bar is required


RE: Donit Tesnit Grafilit EM 1.5 mm - AVKO - 05-27-2020

Guys,
I'll be very appreciated, if you mention why you'd like to make a cross check?
Observed at least 4 times the datasheet and didn't find any clues for additional checking.

Perhaps my knowledge are a bit rusty Smile


RE: Donit Tesnit Grafilit EM 1.5 mm - SGL - 05-28-2020

(05-27-2020, 05:23 PM)AVKO Wrote: Guys,
I'll be very appreciated, if you mention why you'd like to make a cross check?
Observed at least 4 times the datasheet and didn't find any clues for additional checking.

Perhaps my knowledge are a bit rusty Smile
Velin, I ask for this cross check because I think that leakage values are quite optimistic. Rainer


RE: Donit Tesnit Grafilit EM 1.5 mm - AMTEC - 08-27-2020

Cross check: Leakage Test @ 40 bar



The leak rates are within the allowable divergency, except for one stress level (3.38 instead of 3.16), see attached document (dated 2020-08-21).


The cross-check was repeated. The leak rates of the second cross-check and of the mean value of the two cross-checks are within the allowable divergency, see attached document (dated 2020-09-28).

Therefore, the datasheet is accepted for publication.