European Sealing Association
Jawa Corrugated Gasket Typ SW201A 0.8 mm GR 3.0 mm - Printable Version

+- European Sealing Association (https://forum.bacibg.org)
+-- Forum: Flange Gaskets (https://forum.bacibg.org/forumdisplay.php?fid=1)
+--- Forum: Gasket Database (https://forum.bacibg.org/forumdisplay.php?fid=2)
+---- Forum: ESAData Approved Datasheets (https://forum.bacibg.org/forumdisplay.php?fid=10)
+---- Thread: Jawa Corrugated Gasket Typ SW201A 0.8 mm GR 3.0 mm (/showthread.php?tid=214)



Jawa Corrugated Gasket Typ SW201A 0.8 mm GR 3.0 mm - AMTEC - 09-02-2024

Approval of new Datasheet submitted by Jawa Industrie-Dichtungen GmbH (Non-member)

Type: Corrugated Gasket

Material: GR

Since this is a new datasheet, and the tests were not performed by one of the acknowledged independent test houses, we recommend the following cross-check:

- EG@ 200 °C

Other suggestions are welcome.


RE: Jawa Corrugated Gasket 3.0 mm - Teadit - 09-03-2024

Geometry 94x49 is probably a Typo.
No further comments.


RE: Jawa Corrugated Gasket 3.0 mm - Montero - 09-03-2024

Agree with Amtec ( same with Teadit)


RE: Jawa Corrugated Gasket 3.0 mm - Klinger - 09-05-2024

Agree with all above notes.


RE: Jawa Corrugated Gasket 3.0 mm - AMTEC - 09-17-2024

Cross-check:

EG @ 200 °C

The EG values at 200 °C in the cross-check was fit pretty good to the values submitted by the manufacturer. The divergence was within the acceptable limit. Especially at high stresses, the divergence was below 10%.

Therefore, we recommend to publish the characteristics of this material.