European Sealing Association
Klinger KLINGER top-chem 2005 2.0 mm - Printable Version

+- European Sealing Association (https://forum.bacibg.org)
+-- Forum: Flange Gaskets (https://forum.bacibg.org/forumdisplay.php?fid=1)
+--- Forum: Gasket Database (https://forum.bacibg.org/forumdisplay.php?fid=2)
+---- Forum: ESAData Approved Datasheets (https://forum.bacibg.org/forumdisplay.php?fid=10)
+---- Thread: Klinger KLINGER top-chem 2005 2.0 mm (/showthread.php?tid=251)



Klinger KLINGER top-chem 2005 2.0 mm - AMTEC - 03-17-2026

Approval of new Datasheet

Type:        Sheet Gasket
Material:   PTFE

Cross-check: The PQR values at low stresses and RT are higher than values of other PTFE gaskets. Therefore, we recommend a PQR test at  25 MPa @ 150 °C.


RE: Klinger KLINGER top-chem 2005 2.0 mm - SGL - 03-18-2026

I assume that the proposal of AMTEC is a good one, but I must admit that I am not a PTFE expert.


RE: Klinger KLINGER top-chem 2005 2.0 mm - Frenzelit - 03-23-2026

We agree to perform PQR test at 25 MPa @ 150 °C.


RE: Klinger KLINGER top-chem 2005 2.0 mm - Montero - 03-24-2026

We agree to AMTEC


RE: Klinger KLINGER top-chem 2005 2.0 mm - AMTEC - 04-28-2026

Result of Cross-check:

PQR @ 25 MPa / 150 °C

The cross-check was performed, the PQR factor determined in the cross-check is a little bit lower than the PQR factor in the manufacturer´s double test, but the divergence is within an acceptable range.

We recommend to published the datasheet in the current version.