European Sealing Association
Teadit International TF1590 3.0mm - Printable Version

+- European Sealing Association (https://forum.bacibg.org)
+-- Forum: Flange Gaskets (https://forum.bacibg.org/forumdisplay.php?fid=1)
+--- Forum: Gasket Database (https://forum.bacibg.org/forumdisplay.php?fid=2)
+---- Forum: ESAData Approved Datasheets (https://forum.bacibg.org/forumdisplay.php?fid=10)
+---- Thread: Teadit International TF1590 3.0mm (/showthread.php?tid=39)



Teadit International TF1590 3.0mm - root - 01-06-2020

Approval of Data Import from gasketdata.org

Type: sheet gasket
Publication: 04/27/12

Material: PTFE

Link to gasketdata.org


RE: Teadit International TF1590 3.0mm - Donit - 06-08-2020

The data of Qsmax test at RT show that something happen at 160 MPa.
Maybe Qsmax cross-check test shall be done for RT.
I also think that bore intrusion will appear at many tests.

Maja


RE: Teadit International TF1590 3.0mm - Flexitallic - 06-08-2020

Cross check Qsmax data at RT and at elevated temperatures.

Vinay


RE: Teadit International TF1590 3.0mm - AMTEC - 07-20-2020

The following cross-check is defined:

EG @ RT

In the cross-check the divergence was outside the allowable range, see document dated on 2020-09-23. Also in a second cross-check, the deviation was higher than specified in the ESAData spec.

Teadit decided to use the values of the two cross-checks for publication. With the values of these tests the datasheet was updated, see attached document dated on 2020-09-30. The information about bore intrusion was also added.

If nobody has any objections, the datasheet will be accepted.


RE: Teadit International TF1590 3.0mm - Donit - 10-01-2020

(07-20-2020, 11:58 AM)AMTEC Wrote: The following cross-check is defined:

EG @ RT

In the cross-check the divergence was outside the allowable range, see document dated on 2020-09-23. Also in a second cross-check, the deviation was higher than specified in the ESAData spec.

Teadit decided to use the values of the two cross-checks for publication. With the values of these tests the datasheet was updated, see attached document dated on 2020-09-30. The information about bore intrusion was also added.

If nobody has any objections, the datasheet will be accepted.
Agree with proposal.