Approval of Data Import from gasketdata.org
Type: sheet gasket
Publication: 14.01.2013
Material: GR
Link to gasketdata.org
Type: sheet gasket
Publication: 14.01.2013
Material: GR
Link to gasketdata.org
| Poll: Do you agree on publishing the data? You do not have permission to vote in this poll. |
|||
| Yes | 2 | 28.57% | |
| No (Comment in the thread) | 2 | 28.57% | |
| Yes, but cross-check is required (Specify kind of test in the thread) | 2 | 28.57% | |
| Abstain | 1 | 14.29% | |
| Total | 7 vote(s) | 100% | |
| * You voted for this item. | [Show Results] |
|
Frenzelit novaphit SSTC TA-L with XP Tech 2.0mm
|
|
Approval of Data Import from gasketdata.org
Type: sheet gasket Publication: 14.01.2013 Material: GR Link to gasketdata.org
10-05-2020, 05:37 PM
According to our measurements leakage is far too optimistic. I vote for a leakage cross-check at 40 bar.
10-08-2020, 03:14 PM
I think thatĀ that Pqr values must be providedĀ at 3 different gasket surface stresses.
If you disagree, skeep my vote.
10-09-2020, 09:07 PM
Standard requires 3 Pqr values at each temperature
10-12-2020, 09:17 AM
Agree for three gasket loads at each temperature
10-16-2020, 05:25 PM
Since it is a direct import from munster data, not sure if the 3 x stress level rule should applies.
10-19-2020, 10:13 AM
add PQR values at 3 different temperatures
11-10-2020, 07:10 PM
A cross-check (leakage test) at 40 bar was requested. The result oof the cross-check and comparison with the submitted data is attached in this post. The characteristics provided by Frenzelit are conservative, and therefore accepted.
In addition, Frenzelit provided the missing data for the creep relaxation tests. The results fit to the other characteristics sent earlier. Therefore, we suggest that the datasheet can be accepted now. The datasheet is updated and available in the first post of this thread.
11-11-2020, 12:54 PM
Agreed.
|
|
« Next Oldest | Next Newest »
|