Approval of Data Import from gasketdata.org
Type: sheet gasket
Publication: 23.04.2015
Material: FA
Link to gasketdata.org
Type: sheet gasket
Publication: 23.04.2015
Material: FA
Link to gasketdata.org
| Poll: Do you agree on publishing the data? You do not have permission to vote in this poll. |
|||
| Yes | 3 | 42.86% | |
| No (Comment in the thread) | 1 | 14.29% | |
| Yes, but cross-check is required (Specify kind of test in the thread) | 2 | 28.57% | |
| Abstain | 1 | 14.29% | |
| Total | 7 vote(s) | 100% | |
| * You voted for this item. | [Show Results] |
|
Frenzelit novapress UNIVERSAL 2.0mm
|
|
Approval of Data Import from gasketdata.org
Type: sheet gasket Publication: 23.04.2015 Material: FA Link to gasketdata.org
10-08-2020, 03:30 PM
Qsmax test to check Eg values recomended.
Also Pqr values should be added.
10-08-2020, 04:09 PM
standard requires 3 Pqr at each temperature. datasheet provides only 2.
10-12-2020, 08:56 AM
Agree, about at least three temperature (each at three loads).
10-16-2020, 05:58 PM
Since it is a direct import from munster data, not sure if the 3 x stress level rule should applies for PQR.
10-19-2020, 10:06 AM
PQR values should be added
11-10-2020, 07:13 PM
Frenzelit provided the missing data for the creep relaxation tests. The results fit to the other characteristics sent earlier. Therefore, we suggest that the datasheet can be accepted now.
The datasheet is updated and available in the first post of this thread.
11-11-2020, 01:03 PM
I think that Eg value at 80 MPa for room temperature shall be skipped, as it is possible in accordance with new draft of EN 13555 standard.
Otherwise no objections.
11-12-2020, 07:43 PM
|
|
« Next Oldest | Next Newest »
|