Poll: Do you agree on publishing the data?
You do not have permission to vote in this poll.
Yes
20.00%
1 20.00%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
40.00%
2 40.00%
Abstain
40.00%
2 40.00%
Total 5 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
KLINGERSIL C 4409 2.0 mm
#4
Cross-check:
We recommended a cross-check to verify the higher creep/relaxation factor compared to the one published on gasketdata.org..

PQR @ 30 MPa/250 °C

Result of cross-check:
The determined PQR value @30 MPa/250 °C was 0.74. The divergence to the value published by Klinger (0.81) is 0.07 which is above the allowable divergence of 0.05.
The PQR test was repeated, the same PQR value of 0.74 was determined in this second test.
Klinger agreed that PQR of 0.74 @ 30 MPa/250 °C will be published on the datasheet.


Attached Files
.pdf   Klinger Klingersil C4409 FA 92x49x1_9 EN 13555-CR-T 21-371 09_11_2021.pdf (Size: 21.88 KB / Downloads: 0)
.pdf   Klinger Klingersil C4409 FA 92x49x1_9 EN 13555-CR-T 21-374 15_11_2021.pdf (Size: 21.85 KB / Downloads: 0)
.pdf   Klinger-KLINGERSIL C 4409-2.0 mm_Cross-Check_2021-10-20.pdf (Size: 18.28 KB / Downloads: 0)
Reply


Messages In This Thread
KLINGERSIL C 4409 2.0 mm - by AMTEC - 06-22-2021, 11:07 AM
RE: KLINGERSIL C 4409 2.0 mm - by Teadit - 10-22-2021, 12:53 PM
RE: KLINGERSIL C 4409 2.0 mm - by Frenzelit - 11-02-2021, 02:32 PM
RE: KLINGERSIL C 4409 2.0 mm - by AMTEC - 11-05-2021, 01:44 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)