Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
New Layout of Datasheet
#4
I have a concern about point 5.
If Qsmin will be changed from 10 MPa to <10 MPa, this means that a surface pressure of 1 MPa is sufficient to achieve the selected tightness class. We know that this is not true.
We already deleted values of Qsmin at 5 MPa from the published data because the results showed that blowout appears or will appear soon.
I think the manufacturers have in mind what the lowest possible surface pressure on the gasket could be to ensure operational safety, and this is also taken into account in the published data.
If the safety factor is taken into account the minimum gasket stress for 20 bar internal pressure would be 4 MPa. I dont see any problem If Qsmin values are measured at 5 MPa. So we are on the safe side.
Similar is for internal pressure of 40 bar. Minimum gasket stress should be 8 MPa. But I would be fine if the Qsmin values are measured at 10 MPa.
I would rather be on safe side and drop the < sign.

BR, Maja
Reply


Messages In This Thread
New Layout of Datasheet - by AMTEC - 02-14-2022, 05:27 PM
RE: New Layout of Datasheet - by Klinger - 02-15-2022, 10:15 PM
RE: New Layout of Datasheet - by SGL - 02-16-2022, 02:24 PM
RE: New Layout of Datasheet - by Donit - 02-18-2022, 05:14 PM
RE: New Layout of Datasheet - by Frenzelit - 03-08-2022, 01:27 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)