Poll: Do you agree on publishing the datasheet?
You do not have permission to vote in this poll.
Yes
50.00%
3 50.00%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
16.67%
1 16.67%
Abstain
33.33%
2 33.33%
Total 6 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Flexitallic Flexicarb RGS3 1.5 mm
#2
PQR at 300°C for 50MPa load is relatively high, if retesting should be needed, I would sugest to either test this value or test QSminL for 25bar using QA=60MPa load

Other comments: QminL to reach L0,01 is relatively high through all line pressures (twice as high than some SGL sheets), however graphite sheet not tested to 400°C???
Reply


Messages In This Thread
Flexitallic Flexicarb RGS3 1.5 mm - by AMTEC - 06-20-2024, 11:57 AM
RE: Flexitallic Flexicarb RGS3 1.5 mm - by Garlock - 06-20-2024, 04:34 PM
RE: Flexitallic Flexicarb RGS3 1.5 mm - by SGL - 06-21-2024, 05:25 PM
RE: Flexitallic Flexicarb RGS3 1.5 mm - by AMTEC - 07-15-2024, 01:21 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)