Poll: Do you agree on publishing the datasheet?
You do not have permission to vote in this poll.
Yes
50.00%
3 50.00%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
16.67%
1 16.67%
Abstain
33.33%
2 33.33%
Total 6 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Flexitallic Flexicarb RGS3 1.5 mm
#3
I agree with amtec that all characteristics look consistent, the characteristics are also in line with my expectations. Looking at the data, a cross-check is not necessary, but due to our ESAdata specification there has to be a cross-check for every new material. I therefore ask for a cross-check PQR at 300°C and 30 MPa.
Reply


Messages In This Thread
Flexitallic Flexicarb RGS3 1.5 mm - by AMTEC - 06-20-2024, 11:57 AM
RE: Flexitallic Flexicarb RGS3 1.5 mm - by SGL - 06-21-2024, 05:25 PM
RE: Flexitallic Flexicarb RGS3 1.5 mm - by AMTEC - 07-15-2024, 01:21 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)