Poll: Do you agree on publishing the datasheet?
You do not have permission to vote in this poll.
Yes
0%
0 0%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
83.33%
5 83.33%
Abstain
16.67%
1 16.67%
Total 6 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Flexitallic Sigma 588 2.0 mm
#5
+1 Agree here

(06-20-2024, 01:25 PM)Donit Wrote: Qsmin test at 10 bar: the leak rate at 80 MPa is higher as at 60 MPa. This is not usual behaviour unless there is a change in gasket structure.
Gasket thickness at Qsmax sims to be very thin. Dont know how much the PTFE gasket can be destroyed.
I would suggest Pqr test at Qsmax and 250°C to evaluate if the gasket can withstand this parameters as long as necessary.

BR, Maja

+1 Agree Here
Reply


Messages In This Thread
Flexitallic Sigma 588 2.0 mm - by AMTEC - 06-20-2024, 11:38 AM
RE: Flexitallic Sigma 588 2.0 mm - by Donit - 06-20-2024, 01:25 PM
RE: Flexitallic Sigma 588 2.0 mm - by Garlock - 06-20-2024, 04:20 PM
RE: Flexitallic Sigma 588 2.0 mm - by Montero - 06-21-2024, 11:32 AM
RE: Flexitallic Sigma 588 2.0 mm - by AVKO - 06-27-2024, 05:40 PM
RE: Flexitallic Sigma 588 2.0 mm - by AMTEC - 07-15-2024, 01:19 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)