Approval of a new data sheet
Type: spiralwound gasket
Material: GR
Testing lab: In-House
Type: spiralwound gasket
Material: GR
Testing lab: In-House
| Poll: Do you agree on publishing the data? You do not have permission to vote in this poll. |
|||
| Yes | 2 | 28.57% | |
| No (Comment in the thread) | 0 | 0% | |
| Yes, but cross-check is required (Specify kind of test in the thread) | 4 | 57.14% | |
| Abstain | 1 | 14.29% | |
| Total | 7 vote(s) | 100% | |
| * You voted for this item. | [Show Results] |
|
IDT SD10 WS 1.4541-Graphit-St37-10-25-40-80-160
|
|
Approval of a new data sheet
Type: spiralwound gasket Material: GR Testing lab: In-House
10-02-2020, 09:11 AM
Will abstain because I do not know how to vote. Like to add my comments. 1. agree with amtec on eg at 400degC and 2. PQR has a big tolerance (not too big) and at 500degC PQR is higher for 30-130MPa compared to lower temperature, which looks for me strange. Is the 500degC test done on another test rig? standard rig is limited to 400degC.
10-02-2020, 09:53 AM
As it is a new data sheet, a cross check needs to be performed. For me PQR at 30 MPa at 500°C is most surprising, therefore I would vote for this test.
10-07-2020, 02:50 PM
10-13-2020, 04:27 PM
Results of PQR at 500°C obviously doesn't fit. Cross check especially for PQR 30 MPa 500°C required
10-13-2020, 07:32 PM
Cross check PQR @ 500 C at stresses 30, 50, 130, 200 MPa.
Cross-check: PQR @ 30 MPa/500 °C
The PQR value determined in the cross-check is significant lower than the published value (0.75 vs. 0.87). In the repetition of the cross-check, the first was confirmed (0.75). IDT agreed to change PQR @ 30 MPa/500 °C to 0.75. In this case, all PQR appear consistent. The new value will be used in the final datasheet, it can be accepted now. |
|
« Next Oldest | Next Newest »
|