Poll: Do you agree on publishing the data?
You do not have permission to vote in this poll.
Yes
28.57%
2 28.57%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
57.14%
4 57.14%
Abstain
14.29%
1 14.29%
Total 7 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
IDT UNIFLUOR FD01 WS 7551 2.0mm
#1
Thumbs Up 
Approval of a new Data Sheet

Type:  sheet gasket

Material: PTFE

Testing Laboratory: In-house


Attached Files
.pdf   IDT FD01 UNIFLUOR WS 7551 2,0 mm_ESA Approval_a_2020-08-20.pdf (Size: 315.97 KB / Downloads: 3)
.pdf   IDT FD01 UNIFLUOR WS 7551 2,0 mm_ESA Approval_b_2020-11-13.pdf (Size: 316.85 KB / Downloads: 1)
Reply
#2
A cross check is necessary as this is a new data sheet. I agree with the proposal of AMTEC. Regards, Rainer
Reply
#3
(08-21-2020, 01:31 PM)SGL Wrote: A cross check is necessary as this is a new data sheet. I agree with the proposal of AMTEC. Regards, Rainer
Agree.
Reply
#4
tightness results for 16bar are almost identical with results for 40bar (loading)
examples:
16bar: 30MPa = 1,11E-02
40bar: 30MPa = 1,52E-02

16bar: 40MPa = 8,34E-04
40bar: 40MPa = 7,33E-04

as internal pressure is more than double the gap in tightness is supposed to be bigger.
I may ask for x-check 40bar
Reply
#5
A cross check is necessary as this is a new data sheet.
We agree with the proposal of amtec
Reply
#6
Suggest cross check as this is a new data sheet.
We agree with the proposal of amtec.
Reply
#7
Cross-check EG @ RT was recommended. TF asked for an additional cross-check @ 40 bar.

In the leakage test at 40 bar, the results of IDT´s double test could be confirmed.
In the EG test, the divergence at low gasket stresses was higher than the acceptable one. In the repetition of the cross-check, the results of the first cross-check was confirmed. IDT agreed to the replacement of their EG/RT results against the results of the two cross-checks. As there was one outliner at 80 MPa in one of the two tests, this value was ignored in the evaluation.

The results of the cross-checks are attached. The revised datasheet is uploaded in the first post of this thread, it can be accepted in the present form


Attached Files
.pdf   IDT FD01 UNIFLUOR WS 7551 2,0 mm_Cross-Check_2020-11-05.pdf (Size: 173 KB / Downloads: 0)
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)