Poll: Do you agree on publishing the datasheet?
You do not have permission to vote in this poll.
Yes
14.29%
1 14.29%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
42.86%
3 42.86%
Abstain
42.86%
3 42.86%
Total 7 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Klinger KLINGER top-chem2006 2.0 mm
#1
Thumbs Up 
Approval of new Datasheet

Type:        Sheet Gasket
Material:   PTFE

Cross-check: There is a change in the material behaviour @60 MPA/RT and 25 MPA/100 °C, see EG values. Therefore, we recommend to perform a EG test at RT or 100 °C as a cross-check.


Attached Files
.pdf   Klinger-KLINGER top-chem 2006-2.0 mm_ESA Approval_2023-03-01.pdf (Size: 1.27 MB / Downloads: 11)
Reply
#2
I agree with AMTEC: "EG test at RT or 100 °C as a cross-check".

María
Reply
#3
Agree with EG test at RT as a cross-check.
Reply
#4
I would prefer EG test at 100°C
Reply
#5
Cross-check:

A compression test at 100 °C was performed. The result of the cross-check confirms the orignal submitted data, except for the stress level 20 MPa. Klinger ragreed to rduce the EG value @ 20 MPa/100 °C to the result of the cross-check.


Attached Files
.pdf   Klinger-KLINGER top-chem 2006-2.0 mm_Cross-check_2022-03-23.pdf (Size: 158.41 KB / Downloads: 0)
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)