Poll: Do you agree on publishing the datasheet?
You do not have permission to vote in this poll.
Yes
100.00%
4 100.00%
No (Comment in the thread)
0%
0 0%
Total 4 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Final Approval Flexitallic Week 32/2024
#1
Thumbs Up 
Please double-check the attached drafts of the datasheets for

Flexitallic-Flexicarb RGS 3-1.5mm
Flexitallic-Sigma 500-2.0mm
Flexitallic-Sigma 511-2.0mm
Flexitallic-Sigma 533-2.0mm
Flexitallic-Sigma 588-2.0mm

The data are based on the poll started on 20-06-2024.


Attached Files
.pdf   Flexitallic-Sigma 511-2.0mm-Draft.pdf (Size: 631.08 KB / Downloads: 8)
.pdf   Flexitallic-Sigma 588-2.0mm-Draft.pdf (Size: 655.35 KB / Downloads: 8)
.pdf   Flexitallic-Sigma 533-2.0mm-Draft.pdf (Size: 669.1 KB / Downloads: 8)
.pdf   Flexitallic-Flexicarb RGS 3-1.5mm-Draft.pdf (Size: 576.26 KB / Downloads: 4)
.pdf   Flexitallic-Sigma 500-2.0mm-Draft.pdf (Size: 653.05 KB / Downloads: 8)
Reply
#2
Sigma 511 has bore intrusion at 100°C but not at 250°C. Possible?
Sigma 588 has significant higher leakage compared to 10 and 40 bar, which looks weird.
Reply
#3
(08-12-2024, 03:38 PM)Teadit Wrote: Sigma 511 has bore intrusion at 100°C but not at 250°C. Possible?
Sigma 588 has significant higher leakage compared to 10 and 40 bar, which looks weird.
Agree with Teadit comments.
For Sigma 588 the leak rate at 40 bar is much lower as at 25 bar (5, 10 MPa) - this is not typical behaviour of the gasket material.
Reply
#4
(08-12-2024, 03:38 PM)Teadit Wrote: Sigma 511 has bore intrusion at 100°C but not at 250°C. Possible?
Sigma 588 has significant higher leakage compared to 10 and 40 bar, which looks weird.

We contacted Flexitallic and clarified the bore intrusion at 80 MPa / 100 °C and 250 °C:
As the bore intrusion cross had been put in the wrong column, it should have been in the 250C/80MPa column, not 100C/80MPa. This has been changed now.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)