Poll: Do you agree on publishing the data?
You do not have permission to vote in this poll.
Yes
100.00%
5 100.00%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
0%
0 0%
Abstain
0%
0 0%
Total 5 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
AVKO AVKOSEAL eC 3 mm
#1
Thumbs Up 
Approval of Data Import from gasketdata.org

Type: sheet gasket
Publication: 8/16/2017

Link to gasketdata.org


New data were submitted on 2020-11-20. Compared to the characteristics on gasketdata.org they are a little bit more conservative (except Qmin(L) at tightness class 10^-5 and below.

The poll is re-opened.


Attached Files
.pdf   AVKO-AVKOSEAL eC-3.0 mm-ESA Approval-2020-11-23.pdf (Size: 588.18 KB / Downloads: 3)
Reply
#2
Agree to the recommendation of amtec, cross check on PQR because of big tolerance
Reply
#3
There is big thickness decrease during Qsmax test.
I would seggest also Pqr test at 40 MPa, 230°C to check bore intrusion.

I think that remarks about bore intrusion shall be added whenever they occur.

Maja
Reply
#4
I am afraid that this particular product, should be reviewed once again with fresh Datasheet.

The one that we're currently observing does not correlate with the test results.

Asked our QA team to redo all the tests with same parameters. The new Data will be submitted through the regular channels, as it is new material.

Once we've ready Datasheet, same will be published here for review.

Velin
Reply
#5
I vote no based on the comment of 17th June 8:26 PM of Velin (manufacturer himself).
Reply
#6
AVKO recognized some discrepancies in the characteristics of the datasheet. An new datasheet will be generated, and the poll will be repeated.
Reply
#7
agree with new data.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)