Approval of Data Import from gaksetdata.org
Publication Date: 03.07.2012
Link to gasketdata.org
Type: Sheet gasket
Material: Fiber
Publication Date: 03.07.2012
Link to gasketdata.org
Type: Sheet gasket
Material: Fiber
| Poll: Do you agree on publishing the data? You do not have permission to vote in this poll. |
|||
| Yes | 0 | 0% | |
| No (Comment in the thread) | 0 | 0% | |
| Yes, but cross-check is required (Specify kind of test in the thread) | 4 | 80.00% | |
| Abstain | 1 | 20.00% | |
| Total | 5 vote(s) | 100% | |
| * You voted for this item. | [Show Results] |
|
Klinger KLINGERSIL C 4430 2.0 mm
|
|
Approval of Data Import from gaksetdata.org
Publication Date: 03.07.2012 Link to gasketdata.org Type: Sheet gasket Material: Fiber
10-05-2021, 01:21 PM
I agree with AMTEC that a cross-check should be performed since the characteristics have been redetermined and are not identical to those on the previously published data sheet. But I would not do a cross-check on the 40 bar leakage values, but on the 10 or 63 bar leakage values. Why I think so is a general view and has nothing to do with this gasket material: The reason for a cross-check is to find out if there are values which are too progressive, so the cross-check should be performed on the values which are most likely the most progressive ones. It makes no sense to perform a cross-check on the most conservative values.
10-05-2021, 04:00 PM
Agree with Rainer.
10-07-2021, 12:14 PM
Agree with Rainer, as well.
However I would recommend a cross-check only for 63 bar leakage test. According to the graphics and numbers in the tables - on 63 bar pressure, the material has better overall performance than on 40 bar, which does not make sense to me. According the the AMTEC comments bellow the datasheet, 40 bar leakage test is new addition to the document, so perhaps it is a more recent study for this material - i.e. it is logical to cross check the older tests which does not fit with the newer data.
10-14-2021, 12:52 PM
We would also recommend leakage test at 63 bar or PQR 30 MPa 200°C because the value is not really corresponding to the value at 30 MPa 100°C and 300°C. PQR at 200°C is on the same level like PQR at 100°C.
Cross-check:
We recommended a cross-check at 40 bar because the Qmin(L) values for the tightness classes L0,0001 and L0,00001 are lower than the ones for 10 bar, see attached screenshot. But we accept the opinion of the ESA Task Force that a test should not be performed at 40 bar. In this case, a cross-check at 10 bar will be performed. Leakage test @ 10 bar Result of Cross-check: The measured leak rates are within the allowable divergence for cross-checks. For 3 stress levels (in the unloading step from 100 MPa), the divergence is above 3.16, but still below 10 (allowable divergence for leak rate below L0.00001. In addition, Klinger has provoided new double test results for 40 bar which fit better to the results at 63 bar. Therefore, we recommend that the characteristics as sown on the updated datasheet can be published. |
|
« Next Oldest | Next Newest »
|