![]() |
|
IDT FD10 WS 3865 IB SIGRAFLEX Universal Pro with inner eyelet 3.0 mm - Printable Version +- European Sealing Association (https://forum.bacibg.org) +-- Forum: Flange Gaskets (https://forum.bacibg.org/forumdisplay.php?fid=1) +--- Forum: Gasket Database (https://forum.bacibg.org/forumdisplay.php?fid=2) +---- Forum: ESAData Approved Datasheets (https://forum.bacibg.org/forumdisplay.php?fid=10) +---- Thread: IDT FD10 WS 3865 IB SIGRAFLEX Universal Pro with inner eyelet 3.0 mm (/showthread.php?tid=118) |
IDT FD10 WS 3865 IB SIGRAFLEX Universal Pro with inner eyelet 3.0 mm - AMTEC - 08-20-2020 Approval of a new Data Sheet Type: sheet gasket with inner eyelet Material: GR Testing Laboratory: In-house RE: IDT FD10 WS 3865 IB SIGRAFLEX Universal Pro with inner eyelet 3.0 mm - SGL - 08-21-2020 A cross check is necessary as this is a new data sheet. I agree with the proposal of AMTEC. Regards, Rainer RE: IDT FD10 WS 3865 IB SIGRAFLEX Universal Pro with inner eyelet 3.0 mm - EynardRobin - 08-24-2020 I also agree with the proposal of AMTEC, EG at RT. Regards RE: IDT FD10 WS 3865 IB SIGRAFLEX Universal Pro with inner eyelet 3.0 mm - Donit - 09-01-2020 There is a pick of EG value at 180 MPa, RT for second test. I would repeat Qsmax test at RT or omit the EG value at 180 MPa for the second test. This will be aloved in a new standard. Agree with amtec cross-check proposal. Maja RE: IDT FD10 WS 3865 IB SIGRAFLEX Universal Pro with inner eyelet 3.0 mm - Frenzelit - 09-02-2020 Agree with Amtec proposal RE: IDT FD10 WS 3865 IB SIGRAFLEX Universal Pro with inner eyelet 3.0 mm - AMTEC - 11-13-2020 A cross-check for EG @ RT was performed. All EG values are within the allowable divergence, except the one at 180 MPa. Since this EG value was measured only in one of the two test, this outliner can be ignored. In this case, all EG values are in the same range as the ones of the cross-check. The datasheet was updated (see first post in this thread) and it is recommended to accept it in the updated form. |