Approval of a new Data Sheet
Type: sheet gasket with inner eyelet
Material: GR
Testing Laboratory: In-house
Type: sheet gasket with inner eyelet
Material: GR
Testing Laboratory: In-house
| Poll: Do you agree on publishing the data? You do not have permission to vote in this poll. |
|||
| Yes | 0 | 0% | |
| No (Comment in the thread) | 0 | 0% | |
| Yes, but cross-check is required (Specify kind of test in the thread) | 4 | 57.14% | |
| Abstain | 3 | 42.86% | |
| Total | 7 vote(s) | 100% | |
| * You voted for this item. | [Show Results] |
|
IDT FD10 WS 3865 IB SIGRAFLEX Universal Pro with inner eyelet 3.0 mm
|
|
Approval of a new Data Sheet
Type: sheet gasket with inner eyelet Material: GR Testing Laboratory: In-house
08-21-2020, 01:36 PM
A cross check is necessary as this is a new data sheet. I agree with the proposal of AMTEC. Regards, Rainer
08-24-2020, 04:00 PM
I also agree with the proposal of AMTEC, EG at RT. Regards
09-01-2020, 02:02 PM
There is a pick of EG value at 180 MPa, RT for second test.
I would repeat Qsmax test at RT or omit the EG value at 180 MPa for the second test. This will be aloved in a new standard. Agree with amtec cross-check proposal. Maja
09-02-2020, 01:33 PM
Agree with Amtec proposal
11-13-2020, 01:22 PM
A cross-check for EG @ RT was performed. All EG values are within the allowable divergence, except the one at 180 MPa. Since this EG value was measured only in one of the two test, this outliner can be ignored. In this case, all EG values are in the same range as the ones of the cross-check.
The datasheet was updated (see first post in this thread) and it is recommended to accept it in the updated form. |
|
« Next Oldest | Next Newest »
|