Poll: Do you agree on publishing the data?
You do not have permission to vote in this poll.
Yes
0%
0 0%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
57.14%
4 57.14%
Abstain
42.86%
3 42.86%
Total 7 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
IDT FD10 WS 3865 IB SIGRAFLEX Universal Pro with inner eyelet 3.0 mm
#1
Thumbs Up 
Approval of a new Data Sheet
 
Type: sheet gasket with inner eyelet
 
Material: GR
 
Testing Laboratory: In-house


Attached Files
.pdf   IDT FD10 WS 3865 IB SIGRAFLEX Universal Pro with inner eyelet 3,0 mm_ESA Approval_a_2020-08-20.pdf (Size: 328.67 KB / Downloads: 2)
.pdf   IDT FD10 WS 3865 IB SIGRAFLEX Universal Pro with inner eyelet 3,0 mm_ESA Approval_b_2020-11-13.pdf (Size: 328.78 KB / Downloads: 2)
Reply
#2
A cross check is necessary as this is a new data sheet. I agree with the proposal of AMTEC. Regards, Rainer
Reply
#3
I also agree with the proposal of AMTEC, EG at RT. Regards
Reply
#4
There is a pick of EG value at 180 MPa, RT for second test.
I would repeat Qsmax test at RT or omit the EG value at 180 MPa for the second test. This will be aloved in a new standard.
Agree with amtec cross-check proposal. 
Maja
Reply
#5
Agree with Amtec proposal
Reply
#6
A cross-check for EG @ RT was performed. All EG values are within the allowable divergence, except the one at 180 MPa. Since this EG value was measured only in one of the two test, this outliner can be ignored. In this case, all EG values are in the same range as the ones of the cross-check.

The datasheet was updated (see first post in this thread) and it is recommended to accept it in the updated form.


Attached Files
.pdf   IDT FD10 WS 3865 IB SIGRAFLEX Universal Pro with inner eyelet 3,0 mm_Cross-check_2020-11-12.pdf (Size: 24.63 KB / Downloads: 1)
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)