Poll: Do you agree on publishing the datasheet?
You do not have permission to vote in this poll.
Yes
100.00%
6 100.00%
No (Comment in the thread)
0%
0 0%
Total 6 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
IDT-Grooved Gasket WS 1.4571-3803-KD10-20-30-5.0 mm
#1
Thumbs Up 
We recognized a mistake in the input data for creating the datasheet of the material

IDT-Grooved Gasket with graphite layer-WS 1.4571-3803-KD10-20-30-5.0 mm

In the data of the leakage tests at 10 and 40 bar in the unoading curve starting at 60 MPa there was a gasket stress level indicated with 40 MPa instead of 20 MPa. This mistake influences the characteristics QSmin(L) slightly.

In the attached draft of the revised datasheet the characteristics which will change are highlighted yellow.


Attached Files
.pdf   IDT-Grooved Gasket with graphite layer-WS 1.4571-3803-KD10-20-30-5.0 mm-DRAFT03.pdf (Size: 269.59 KB / Downloads: 11)
Reply
#2
Note1: Compared to 10bar, 40bar and 80bar Leak rates curves of 160bar (on last page) indicate that (longer?) holding time for mass spectrometere is accurate, but the scale looks differrent than expected. All other graphs always do end up with 1,0 x 10 E-02 but the 160bar does end up within 1,0x10E-01 sector if less than 31MPa is given.
Note2: Where can i find these 31MPa in table "Minimum required gasket stress in service (QSmin/L) --> Here, <20MPa is given instead of 31MPa
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)