Approval of Data Import from gasketdata.org
Type: sheet gasket
Publication: 02.07.2013
Material: GR
Link to gasketdata.org
Type: sheet gasket
Publication: 02.07.2013
Material: GR
Link to gasketdata.org
| Poll: Do you agree on publishing the data? You do not have permission to vote in this poll. |
|||
| Yes | 1 | 14.29% | |
| No (Comment in the thread) | 2 | 28.57% | |
| Yes, but cross-check is required (Specify kind of test in the thread) | 2 | 28.57% | |
| Abstain | 2 | 28.57% | |
| Total | 7 vote(s) | 100% | |
| * You voted for this item. | [Show Results] |
|
Frenzelit novaphit SSTC TA-L with XP Tech 1,6 mm
|
|
Approval of Data Import from gasketdata.org
Type: sheet gasket Publication: 02.07.2013 Material: GR Link to gasketdata.org
10-05-2020, 11:38 AM
EG at RT looks a little bit strange
10-07-2020, 11:15 AM
For Frenzelit novaphit SSTC TA-L with XP 2.0 mm I voted for a leakage cross-check at 40 bar. If this cross-check confirms that the data provided by Frenzelit are within the allowable divergence compared to the cross-check, my vote for the 1.6 mm thick material changes to YES. If the cross-check of the 2.0 mm thick material should show that the allowable divergence is not met, I vote for a leakage cross-check at 40 bar for the 1.6 mm thickness as well.
10-07-2020, 03:15 PM
Standard requires that Pqr values are measured at 3 different gasket surface stresses.
In this datasheet the Pqr was measured only at two different gasket surface stresses. Additional data shall be added before publishing.
10-09-2020, 08:47 PM
Standard requires that Pqr values are measured at 3 different gasket surface stresses.
10-12-2020, 09:15 AM
Agree for 3 gasket loads at each temperature.
10-19-2020, 11:19 AM
Frenzelit provided the missing data for the creep relaxation tests. The results fit to the other characteristics sent earlier. Therefore, we suggest that the datasheet can be accepted now.
The datasheet is updated and available in the first post of this thread.
11-11-2020, 12:51 PM
Agreed.
|
|
« Next Oldest | Next Newest »
|