Approval of Data Import from gaksetdata.org
Publication Date: 03.07.2012
Link to gasketdata.org
Type: Sheet gasket
Material: Fiber
Publication Date: 03.07.2012
Link to gasketdata.org
Type: Sheet gasket
Material: Fiber
| Poll: Do you agree on publishing the data? You do not have permission to vote in this poll. |
|||
| Yes | 0 | 0% | |
| No (Comment in the thread) | 0 | 0% | |
| Yes, but cross-check is required (Specify kind of test in the thread) | 5 | 83.33% | |
| Abstain | 1 | 16.67% | |
| Total | 6 vote(s) | 100% | |
| * You voted for this item. | [Show Results] |
|
Klinger KLINGERSIL C 4500 2.0 mm
|
|
Approval of Data Import from gaksetdata.org
Publication Date: 03.07.2012 Link to gasketdata.org Type: Sheet gasket Material: Fiber
10-04-2021, 03:31 PM
Agree with cross-check recommendation: EG @ 300 °C.
Maja
10-05-2021, 01:25 PM
Agree with cross-check recommendation EG @ 300 °C of AMTEC and DONIT.
10-05-2021, 04:03 PM
For me ok as recommended above.
10-06-2021, 05:24 PM
To me it seems that the numbers in the table responsible for Eg@300C are misplaced and shifted, i.e. I agree with AMTEC recommendation. Perhaps it'll be best to do a cross check.
10-14-2021, 12:50 PM
We agree with recommended crosscheck
Cross-check:
EG @ 300°C Result of Cross-check: The moduli of elasticity are within the allowable divergence for cross-checks. Only at the first gasket stress level (20 MPa), the value is much higher than the values of the double test. We believe that this value is a result of the test procedure with heating up at a gasket stress level of 20 MPa. Also for othe fiber based sheet materials this effect can be recognized. We suggest to declare this value as an outliner. Therefore, we recommend that the characteristics as sown on the updated datasheet can be published. |
|
« Next Oldest | Next Newest »
|