Poll: Do you agree on publishing the data?
You do not have permission to vote in this poll.
Yes
20.00%
1 20.00%
No (Comment in the thread)
20.00%
1 20.00%
Yes, but cross-check is required (Specify kind of test in the thread)
40.00%
2 40.00%
Abstain
20.00%
1 20.00%
Total 5 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
GORE® Universal Pipe Gasket 6.0mm
#2
Leakage at 40 bar (for unloading to 5 MPa the divergence in the measured leak rates is too high): ESAdata specification allows the following procedure in 5.4.2: "If a value (typically at the end of the graph, e. g. the 5 MPa unloading leakage value) is outside of the allowable divergency, one possibility to accept the rest of the values is to delete this value"
I spoke to Daniel Bissett (GORE). He would be fine with this approach. To make it look better it makes sense not only to delete the 5 MPa unloading value for QA 30, 40 and 80 MPa, but also for 60 MPa.
If these values are deleted, my vote changes from "no" to "yes".
Reply


Messages In This Thread
GORE® Universal Pipe Gasket 6.0mm - by root - 01-06-2020, 12:12 AM
RE: GORE® Universal Pipe Gasket 6.0mm - by SGL - 06-22-2020, 02:07 PM
RE: GORE® Universal Pipe Gasket 6.0mm - by AMTEC - 10-05-2020, 07:16 PM
RE: GORE® Universal Pipe Gasket 6.0mm - by AMTEC - 09-30-2020, 03:58 PM
RE: GORE® Universal Pipe Gasket 6.0mm - by Donit - 10-06-2020, 11:24 AM
RE: GORE® Universal Pipe Gasket 6.0mm - by IDT - 10-01-2020, 08:13 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)