Poll: Do you agree on publishing the data?
You do not have permission to vote in this poll.
Yes
37.50%
3 37.50%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
50.00%
4 50.00%
Abstain
12.50%
1 12.50%
Total 8 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
IDT Corrugated metallic gasket with graphite layer, WD10, WS1.4571/3803 3 mm
#6
Looking the Leak Rates at 80 bar:
At 80MPa/80bar for the first test the result is 1,15E-05
On the second test the result is 8,54E-06 (???)

At 100MPa/80bar first test shows 8,69E-06
Second one 1,09E-05

I believe that those are swapped, so perhaps a cross check is really necessary, or at least a good review on all submitted table data.
Perhaps a x-check will be easier and more reliable
Reply


Messages In This Thread
RE: IDT Corrugated metallic gasket with graphite layer, WD10, WS1.4571/3803 3 mm - by AVKO - 08-12-2020, 12:56 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)