Poll: Do you agree on publishing the data?
You do not have permission to vote in this poll.
Yes
20.00%
1 20.00%
No (Comment in the thread)
20.00%
1 20.00%
Yes, but cross-check is required (Specify kind of test in the thread)
40.00%
2 40.00%
Abstain
20.00%
1 20.00%
Total 5 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
GORE® Universal Pipe Gasket 6.0mm
#5
The following cross-check is recommended:

PQR at 10 MPa/RT

Comment to the other replies of the Task force:
Klinger: The increasing of the leak rate at gasket stress levels above 60 MPa is probably caused by too short measuring times. The characteristics are not influenced by this behavior.
SGL: During the unloading to 5 MPa a behaviour like a blow-out occurs. Gore is contacted to either delete these values or to adapt them to the higher leak rate of the double test. If the higher leak rates are used, the gasket characteristics are more or less identical.

Result of the cross-check is within the acceptable divergence range. Therefore the datasheet is accepted.


Attached Files
.pdf   GORE®_STA-PURE(tm) Pipe Gaskets Style 1500_6,0_Cross-check_2020-10-05.pdf (Size: 67.45 KB / Downloads: 3)
Reply


Messages In This Thread
GORE® Universal Pipe Gasket 6.0mm - by root - 01-06-2020, 12:12 AM
RE: GORE® Universal Pipe Gasket 6.0mm - by SGL - 06-22-2020, 02:07 PM
RE: GORE® Universal Pipe Gasket 6.0mm - by AMTEC - 10-05-2020, 07:16 PM
RE: GORE® Universal Pipe Gasket 6.0mm - by AMTEC - 09-30-2020, 03:58 PM
RE: GORE® Universal Pipe Gasket 6.0mm - by Donit - 10-06-2020, 11:24 AM
RE: GORE® Universal Pipe Gasket 6.0mm - by IDT - 10-01-2020, 08:13 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)