Poll: Do you agree on publishing the data?
You do not have permission to vote in this poll.
Yes
0%
0 0%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
83.33%
5 83.33%
Abstain
16.67%
1 16.67%
Total 6 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Klinger KLINGERSIL C 4500 2.0 mm
#7
Cross-check:

EG @ 300°C

Result of Cross-check:
The moduli of elasticity are within the allowable divergence for cross-checks. Only at the first gasket stress level (20 MPa), the value is much higher than the values of the double test. We believe that this value is a result of the test procedure with heating up at a gasket stress level of 20 MPa. Also for othe fiber based sheet materials this effect can be recognized. We suggest to declare this value as an outliner.

Therefore, we recommend that the characteristics as sown on the updated datasheet can be published.


Attached Files
.pdf   Klinger-KLINGERSIL C 4500-2.0 mm_Cross-check_2021-09-03.pdf (Size: 36.06 KB / Downloads: 3)
Reply


Messages In This Thread
Klinger KLINGERSIL C 4500 2.0 mm - by AMTEC - 06-22-2021, 11:07 AM
RE: Klinger KLINGERSIL C 4500 2.0 mm - by Donit - 10-04-2021, 03:31 PM
RE: Klinger KLINGERSIL C 4500 2.0 mm - by SGL - 10-05-2021, 01:25 PM
RE: Klinger KLINGERSIL C 4500 2.0 mm - by Teadit - 10-05-2021, 04:03 PM
RE: Klinger KLINGERSIL C 4500 2.0 mm - by AVKO - 10-06-2021, 05:24 PM
RE: Klinger KLINGERSIL C 4500 2.0 mm - by AMTEC - 10-19-2021, 06:44 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)