Poll: Do you agree on publishing the datasheet?
You do not have permission to vote in this poll.
Yes
100.00%
6 100.00%
No (Comment in the thread)
0%
0 0%
Total 6 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
IDT-Grooved Gasket WS 1.4571-3803-KD10-20-30-5.0 mm
#2
Note1: Compared to 10bar, 40bar and 80bar Leak rates curves of 160bar (on last page) indicate that (longer?) holding time for mass spectrometere is accurate, but the scale looks differrent than expected. All other graphs always do end up with 1,0 x 10 E-02 but the 160bar does end up within 1,0x10E-01 sector if less than 31MPa is given.
Note2: Where can i find these 31MPa in table "Minimum required gasket stress in service (QSmin/L) --> Here, <20MPa is given instead of 31MPa
Reply


Messages In This Thread
RE: IDT-Grooved Gasket WS 1.4571-3803-KD10-20-30-5.0 mm - by Garlock - 12-13-2022, 05:34 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)