03-18-2026, 02:54 PM
I assume that the proposal of AMTEC is a good one, but I must admit that I am not a PTFE expert.
| Poll: Do you agree o publishing the datasheet? You do not have permission to vote in this poll. |
|||
| Yes | 0 | 0% | |
| No (Comment in the thread) | 0 | 0% | |
| Yes, but cross-check is required (Specify kind of test in the thread) | 3 | 75.00% | |
| Abstain | 1 | 25.00% | |
| Total | 4 vote(s) | 100% | |
| * You voted for this item. | [Show Results] |
|
Klinger KLINGER top-chem 2005 2.0 mm
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Klinger KLINGER top-chem 2005 2.0 mm - by AMTEC - 03-17-2026, 08:15 PM
RE: Klinger KLINGER top-chem 2005 2.0 mm - by SGL - 03-18-2026, 02:54 PM
RE: Klinger KLINGER top-chem 2005 2.0 mm - by Frenzelit - 03-23-2026, 04:21 PM
RE: Klinger KLINGER top-chem 2005 2.0 mm - by Montero - 03-24-2026, 03:09 PM
RE: Klinger KLINGER top-chem 2005 2.0 mm - by AMTEC - 04-28-2026, 07:01 PM
|