Approval of Data Import from gasketdata.org
Type: sheet gasket
Publication: 8/14/2019
Link to gasketdata.org
Type: sheet gasket
Publication: 8/14/2019
Link to gasketdata.org
| Poll: Do you agree on publishing the data? You do not have permission to vote in this poll. |
|||
| Yes | 4 | 57.14% | |
| No (Comment in the thread) | 0 | 0% | |
| Yes, but cross-check is required (Specify kind of test in the thread) | 2 | 28.57% | |
| Abstain | 1 | 14.29% | |
| Total | 7 vote(s) | 100% | |
| * You voted for this item. | [Show Results] |
|
Donit Tesnit Grafilit EM 1.5 mm
|
|
Approval of Data Import from gasketdata.org
Type: sheet gasket Publication: 8/14/2019 Link to gasketdata.org
Leakage cross check at 40 bar is required
05-27-2020, 05:23 PM
Guys,
I'll be very appreciated, if you mention why you'd like to make a cross check? Observed at least 4 times the datasheet and didn't find any clues for additional checking. Perhaps my knowledge are a bit rusty
05-28-2020, 12:39 PM
(05-27-2020, 05:23 PM)AVKO Wrote: Guys,Velin, I ask for this cross check because I think that leakage values are quite optimistic. Rainer
Cross check: Leakage Test @ 40 bar
The leak rates are within the allowable divergency, except for one stress level (3.38 instead of 3.16), see attached document (dated 2020-08-21). The cross-check was repeated. The leak rates of the second cross-check and of the mean value of the two cross-checks are within the allowable divergency, see attached document (dated 2020-09-28). Therefore, the datasheet is accepted for publication. |
|
« Next Oldest | Next Newest »
|