Poll: Do you agree on publishing the data?
You do not have permission to vote in this poll.
Yes
57.14%
4 57.14%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
28.57%
2 28.57%
Abstain
14.29%
1 14.29%
Total 7 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Donit Tesnit Grafilit EM 1.5 mm
#1
Thumbs Up 
Approval of Data Import from gasketdata.org

Type: sheet gasket
Publication: 8/14/2019

Link to gasketdata.org


Attached Files
.pdf   Donit Tesnit Grafilit EM_ESA Approval_2020-05-18.pdf (Size: 114.92 KB / Downloads: 13)
Reply
#2
Leakage cross check at 40 bar is required
Reply
#3
Guys,
I'll be very appreciated, if you mention why you'd like to make a cross check?
Observed at least 4 times the datasheet and didn't find any clues for additional checking.

Perhaps my knowledge are a bit rusty Smile
Reply
#4
(05-27-2020, 05:23 PM)AVKO Wrote: Guys,
I'll be very appreciated, if you mention why you'd like to make a cross check?
Observed at least 4 times the datasheet and didn't find any clues for additional checking.

Perhaps my knowledge are a bit rusty Smile
Velin, I ask for this cross check because I think that leakage values are quite optimistic. Rainer
Reply
#5
Cross check: Leakage Test @ 40 bar



The leak rates are within the allowable divergency, except for one stress level (3.38 instead of 3.16), see attached document (dated 2020-08-21).


The cross-check was repeated. The leak rates of the second cross-check and of the mean value of the two cross-checks are within the allowable divergency, see attached document (dated 2020-09-28).

Therefore, the datasheet is accepted for publication.


Attached Files
.pdf   Donit Tesnit Grafilit EM_Cross-Check_2020-08-21.pdf (Size: 197.46 KB / Downloads: 2)
.pdf   Donit Tesnit Grafilit EM_Cross-Check_2020-09-28.pdf (Size: 257.01 KB / Downloads: 2)
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)