Approval of Data Import from gasketdata.org
Type: sheet gasket
Publication: 04/27/12
Material: PTFE
Link to gasketdata.org
Type: sheet gasket
Publication: 04/27/12
Material: PTFE
Link to gasketdata.org
| Poll: Do you agree on publishing the data? You do not have permission to vote in this poll. |
|||
| Yes | 6 | 75.00% | |
| No (Comment in the thread) | 0 | 0% | |
| Yes, but cross-check is required (Specify kind of test in the thread) | 2 | 25.00% | |
| Abstain | 0 | 0% | |
| Total | 8 vote(s) | 100% | |
| * You voted for this item. | [Show Results] |
|
Teadit International TF1590 3.0mm
|
|
Approval of Data Import from gasketdata.org
Type: sheet gasket Publication: 04/27/12 Material: PTFE Link to gasketdata.org
06-08-2020, 02:00 PM
The data of Qsmax test at RT show that something happen at 160 MPa.
Maybe Qsmax cross-check test shall be done for RT. I also think that bore intrusion will appear at many tests. Maja
06-08-2020, 05:22 PM
Cross check Qsmax data at RT and at elevated temperatures.
Vinay
The following cross-check is defined:
EG @ RT In the cross-check the divergence was outside the allowable range, see document dated on 2020-09-23. Also in a second cross-check, the deviation was higher than specified in the ESAData spec. Teadit decided to use the values of the two cross-checks for publication. With the values of these tests the datasheet was updated, see attached document dated on 2020-09-30. The information about bore intrusion was also added. If nobody has any objections, the datasheet will be accepted.
10-01-2020, 02:56 PM
(07-20-2020, 11:58 AM)AMTEC Wrote: The following cross-check is defined:Agree with proposal. |
|
« Next Oldest | Next Newest »
|