Poll: Do you agree on publishing the data?
You do not have permission to vote in this poll.
Yes
60.00%
3 60.00%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
20.00%
1 20.00%
Abstain
20.00%
1 20.00%
Total 5 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
GORE® Universal Pipe Gasket 3.0mm
#1
Thumbs Up 
Approval of Data Import from gasketdata.org

Type: sheet gasket
Publication: 02/02/16

Material: PTFE

Link to gasketdata.org


Attached Files
.pdf   GORE®_STA-PURE(tm) Pipe Gaskets Style 1500_3,0_Vers 1_ESA Approval_2020-05-18.pdf (Size: 111.85 KB / Downloads: 8)
Reply
#2
All submitted GORE UPG show increase in leakage beginning at 60MPa rather than getting tighter. This might indicate destruction of gasket.I propose x check of qsmax RT with visual inspection of gasket.
Reply
#3
It is recommended to accept the datasheet without a cross-check.

Comment to the other replies of the Task force:

Klinger: The increase of the leak rate at gasket stress levels above 60 MPa is probably caused by too short measuring times. The characteristics are not influenced by this behavior.
Reply
#4
Accepted from IDT
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)