Poll: How shall we treat datasheets for tongue and groove applications?
You do not have permission to vote in this poll.
Statement on datasheet is sufficient.
0%
0 0%
One additional gasket type "Type TG" should be added.
60.00%
3 60.00%
For each gasket type a "Type TG" option should be added.
20.00%
1 20.00%
Other, specified in post.
20.00%
1 20.00%
Total 5 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Gaskets for tongue & groove application
#1
In EN 13555 there are the following dimensions for the test samples defined:



1. DN40/PN40 according EN 1514-1 to EN 1514-7


2. NPS 4 Class 300 according to EN 12560-1 to  EN 12560-7


3. For the use in a tongue and groove, the gasket must fit into the groove of EN 1092-1 or EN 1759-1 unstead of having the geometry of EN 1514 or EN 12560 series


4.For tapes an outer diameter of 110 mm is defined




Shall the gasket characteristics for tongue & groove application be listed together with the EN1514 or EN 12560 characteristics, or shall they be listed in one category "Type TG" for all gasket types, or do we need for each gasket type an additional category (e.g. "Type TG - sheet gasket").



Please select one of the options in the poll or share your opinion in a post.
Reply
#2
I think we could add the TG gaskets into the "non-standard" folders.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)