Poll: Do you agree on publishing the data?
You do not have permission to vote in this poll.
Yes
83.33%
5 83.33%
No (Comment in the thread)
0%
0 0%
Yes, but cross-check is required (Specify kind of test in the thread)
0%
0 0%
Abstain
16.67%
1 16.67%
Total 6 vote(s) 100%
* You voted for this item. [Show Results]

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
SGL SIGRAFLEX HOCHDRUCK PRO V15011Z3IP 1.5mm
#1
Thumbs Up 
Approval of Data Import from gasketdata.org

Type: sheet gasket
Publication: 09.04.2019

Material:GR

Link to gasketdata.org


Attached Files
.pdf   SGL Carbon_SIGRAFLEX HOCHDRUCK PRO V15011Z3IP_1,5 mm_ESA Approval_2020_07_21.pdf (Size: 131.01 KB / Downloads: 10)
Reply
#2
Maybe we should decide to use the average of 3 E-Modul test at such behaviour (results with runaway values)? Some materials seems to have such trend and more tests would give better results to perform calculations. Third test could be performed by inhouse testing.
Reply
#3
(07-22-2020, 07:21 AM)Teadit Wrote: Maybe we should decide to use the average of 3 E-Modul test at such behaviour (results with runaway values)? Some materials seems to have such trend and more tests would give better results to perform calculations. Third test could be performed by inhouse testing.
Agree with proposal of Teadit.

If Pqr test at 300°C was performed later on other test samples, the result can be slightly different from the first tested samples.
Here I would expect the value of 0,92.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)